Categories
Contact Us
Add: No.31 Zhangba Er Road, Xian, Shaanxi, China
Tel: +86-29-68723798
Mob: +8613991913180
E-mail: [email protected]
Knowledge
Home > Knowledge > Content
Industrial embroidery machine manufacturers explain how to maintain the machine
Sep 07, 2021

An industrial embroidery machine is expensive, its service life, in addition to the quality of the brand, is also related with later daily using habits and maintenance .

In order to improve the efficiency of machine work, increase the income in production, extend the return on investment of the machine, machine maintenance is imperative. Industrial embroidery machine manufacturers explain how to maintain the machine.

Industrial embroidery machine

1.Hook: it should be each shift (8 hours) with a brush (or blow with compressed air) to remove non-woven dust and wire chips, every two weeks should open the needle plate, do a thoroughly washed out, each clean up after a small drop of sewing oil, not to make oil pollution embroidery.

2. Frame and drive guide rail: Mainly the cleaning of debris in the rail, it is often embroidered when cut the line, non-woven debris into , affecting the movement of the frame, operator must always pay attention to check to avoid debris into, according to the surface lubrication of the rails in a timely manner to replenish , it should be 2 times a week (such as oil loss machine will appear fancy position, broken lines, noise increase, seriously affecting the normal operation ).

Frame and drive guide rail

3.Head clamp: Pick the line reed and alarm plate should always keep clean, once appearing dust and other pollution, which will make the disconnect alarm failure, to bring normal work inconvenience, At the same time pay attention to the rotation of the line wheel, such as uneven rotation, inflexible, it is possible that the hole has felt mud stuck and other effects, which should be cleared to ensure smooth line crossing, the component does not need to be lubricant.

4. Needle bar frame roller slide guide: Due to the more exposed, it must be regularly checked, cleaned to ensure that the color change mechanism is working properly, once a week with lubricant.

5. Each rotating part: it should pay attention to cleaning, with the remaining wire mass can not be arbitrarily placed, in order to prevent the rotating shaft or wheel and other entanglement and unnecessary failure, especially it can not put the line mass and other debris on the table, in case the first line group is wrapped in the lower axis or Y axis synchronization belt under the table, will cause the distortion of the synchronization belt, damage, frame can not move or not in place, so that embroidery works are scrapped, the industrial embroidery machine can not continue to work and stop production.


If you want to know us, please contact: [email protected]

  • Newsletter
  • Categories
  • Contact Us
    Add: No.31 Zhangba Er Road, Xian, Shaanxi, China
    Tel: +86-29-68723798
    Mob: +8613991913180
    E-mail: [email protected]
  • QR Code
  • Copyright © 2016-2020 Topeagle International Ltd All rights reserved.