After the epidemic, people's demand for flat masks has soared, so the sales of flat mask machines have also soared. However, after many customers purchase it, they will run smoothly and encounter many problems on installation and debugging.
There are three major problems with the production of face mask machines:
1. Insufficient recovery rate, recruitment difficulties;
2. The production of mask equipment is unstable, a lot of problems will occur after the equipment runs for a period of time, the speed is slow, sometimes it cannot be started.
3. There are still many difficulties in production qualification, guarantee, raw material procurement and so on.
There are a number of reasons for device stability:
1. The equipment's own problems, design defects, component quality problems, etc.;
2. The quality of the melting cloth is uneven, which is also a major factor affecting production.
The width and thickness of the melting and nonwoven fabrics will directly affect the normal use of mechanical equipment. In the actual production process, the width and thickness of the cloth may exceed the forming range of the machine in the plastic process, there will be many problems in the production process of the nasal beam belt. When you encounter a problem, you will lose a lot of time, energy and materials during the debugging process, which is very scary.
If the material band is not well formed, it may cause the mask to not fold smoothly, the nose clip line is stacked, the compression welding of the body does not fit, or the welding effect of the sealing edge is not perfect, which is also a common phenomenon in the production of masks.
The width, thickness and flexibility of the nose bars can affect the commissioning of the flat mask machine. If the nose bar is not good, the packaging is not smooth, in addition, the nose bar is too thick, it will not only break the blade, but also lead to the cutting not continuous, or the cutting angle not good, resulting in the accumulation or dislocation of the nasal bar. Our machines require that the bridge of the nose beam which must be centered on the middle.
The elasticity, thickness and flat band of the earband pull have great interference with the good speed in the actual production process. Adjusting the ear band welder is not difficult for experienced automation engineers. If you know it, you will know the actual structure of the action. In fact, in the actual production, there will also be a variety of small problems, such as pulling the line, cutting line, welding failure, bias welding, melting non-conformity, resulting in the production of a large number of bad products, then it is necessary to debug and maintain many links. Whether it is a straight-line pull belt, a reciprocating pull belt or a rotating pull belt, it has its own characteristics. In terms of efficiency, the pull belt is higher than the rotating band.
Debugging experts rely on perseverance to debug the flat mask machine in a short time, because this is not a short-term job. If you have more related debugging issues, please consult us.
If you want to know us, please contact: [email protected]