Categories
Contact Us
Add: No.31 Zhangba Er Road, Xian, Shaanxi, China
Tel: +86-29-68723798
Mob: +8613991913180
E-mail: [email protected]
Knowledge
Home > Knowledge > Content
Maintenance method of Automatic Pocket Welting Machine
Apr 19, 2021

Automatic pocket welting machine is a kind of more precise machinery, commonly used by people. When we buy a machine, as long as it is installed properly, it can guarantee normal operation.Maintenance method of Automatic Pocket Welting Machine.jpeg

A qualified machine can last 20-30 years even if it is frequently used when maintenance is strengthened. However, some users did not use the machine for a long time, there were problems such as loud noise, heavy machine, or broken needle and thread. The occurrence of these problems, in addition to its performance is not mastered, more importantly, the operator does not do a good job of the daily maintenance of the machine. In order to achieve its proper service efficiency and prolong service life, it is necessary to pay attention to routine maintenance.

It is very important to do a good job and keep a automatic pocket welting machine clean at ordinary times. In order to prevent dust from intruding into the inside of the machine head, the three-bucket or five-bucket machine with hiding head box should be put into the bedroom box in time after being used up. When the flat-bed patching machine without a horizontal box is not in use, it can be covered with a cloth sheet or a plastic sheet on the head VII. After stopping use, the belt should be removed from the wheel to prevent children from stepping on, interrupting the needle or thread clamping.

If there is accumulated fluff and oil stains inside the shuttle bed and other parts, it should be removed in time. under normal circumstances, it is best to clean the inside of the shuttle bed and the interdental spaces between the feed dog with a brush once every week. The shuttle bed should be wiped clean with a cloth strip. Do not use water or a damp cloth with water to scrub the parts to prevent the parts from rusting. After removing and wiping each time, add a little oil to the runway of the shuttle rack to lubricate the parts and operate flexibly. When installing the shuttle bed, do not install the internal parts upside down, otherwise problems such as thread breakage, thread clamping, and injection will occur. When disassembling and installing, please refer to the sequence and description of the part number of the shuttle bed.

In addition, the parts inside the machine head that are not easy to remove and wipe, such as the needle bar, compression bar, lower shaft, and cloth feed shaft, can be wrapped around a screwdriver and inserted in to clean. In short, the entire machine head must be cleaned frequently and kept clean. When using the automatic pocket welting machine, do not reverse the wheel, otherwise the thread will be clamped and broken.


If you want to know us, please contact: [email protected]

  • Newsletter
  • Categories
  • Contact Us
    Add: No.31 Zhangba Er Road, Xian, Shaanxi, China
    Tel: +86-29-68723798
    Mob: +8613991913180
    E-mail: [email protected]
  • QR Code
  • Copyright © 2016-2020 Topeagle International Ltd All rights reserved.